FlowStar Care Guide

How to wash, dry, store and travel with your FlowStar, what to do after a wet or dusty festival, and how to keep UV-reactive prints bright.

How to clean a FlowStar

Every ForeverFlow FlowStar is a printed polyester spinning cloth, so wash it by hand, never in a washing machine. It's all about being gentle. For small marks, a damp cloth or a little silicone brush is usually all it needs.

  1. Fill a sink or bucket with cool or lukewarm water and add a small amount of gentle soap or detergent.
  2. Let your FlowStar sit in the water for a little bit to help loosen any dirt or buildup.
  3. Use your hands or a soft brush to gently clean any stubborn spots, especially around the points.
  4. Rinse it really well with fresh water until all the soap is gone.
  5. Lay it out flat to dry, flipping it every hour until it's completely dry.

Keep it away from harsh cleaning products, bleach and excessive heat.

Drying

Lay it out flat to dry and flip it over every hour. Don't put it in the dryer, don't hang it up to dry, and don't leave it drying in the sun. Skip the iron too.

Storage

Always make sure it's completely dry before storing it. Avoid leaving it somewhere damp, and never stuff it into a bag while it's still wet. Hanging it up or storing it flat is best, and folding it neatly is fine too, just don't fold or squeeze it too tightly. Keep it out of direct sunlight and away from anything that could snag the fabric, like velcro, zippers or hooks.

Handling

Take off sharp jewelry, rings, bracelets or accessories that could catch the fabric or pull at the stitching. Be mindful of rough surfaces like concrete or pavement, which cause unnecessary wear and tear.

Taking it to a festival

Give your FlowStar its own bag so it doesn't snag on zippers, velcro, hooks or other props, and don't leave it baking in a hot car.

Rain, mud and dust

A wet FlowStar is heavier and spins differently until it dries. Lay it out flat to dry before packing. Let mud dry, gently brush it off, then wash it by hand.

UV-reactive prints and fading

Some designs are UV reactive and glow under blacklight; each product page says which. UV-reactive designs often shift in tone under UV light. Like any printed fabric, colors can fade with lots of direct sun, so store it and dry it out of the sun.

Checking the stitching

A few little threads sticking up are normal and can be snipped off. Loose threads can be resewn. For a major issue or defect, email forever@foreverflow.co.